Type H-2358 Sample Cells-Single Open Ended

TECHREF® Type H-2358 Step 1
Assembly Step 1: Select assembly, remove outer ring, & place film over cup.
TECHREF® Type H-2358 Sample Cell Step 2
Step 2: Gently place ring back over film with jig tool.
TECHREF® Type H-2358 Sample Cell Step 3
Step 3: Push jig tool all the way down, until film is smooth. Remove jig tool.

Product Dimensions

Overall Diameter With Flange: 48 mm

Overall Height: 18.5 mm

TECHREF® Type H-2358 Sample Cell are designed and manufactured specifically for use with the Carousel/Turntable models of Horiba X-Ray Fluorescence Analyzers.

  • Designed to help prevent contamination from dust or debris when the Sample Cell is moving with the carousel/turntable, leading to more accurate testing results.
  • Allows close membrane-to-membrane fit with the 2nd membrane in the analyzer, providing better repeatability during low level analysis.
  • TECHREF® Type H-2358 Sample Cells are Horiba tested and approved.
  • May also be used in single-load Horiba X-Ray Fluorescence Analyzers, single-load XOS,and Xenemetrix X-Ray Fluorescence Analyzers.
  • Manufactured by an injection-molding process from a virgin low-density polyethylene.
  • Packaged 48 per box in a re-closeable chipboard box. The Type H-2358 Sample Cells are sold by the box only.
  • Each Sample Cell consists of two parts:
    • a closed-bottom cup with an outer, open ring, which holds and seals the desired film after sample is loaded.
    • There are two fill lines in the interior of the cup for consistent sample size.
    • Each ring, cup assembly has a mating locking line to help prevent leakage. For volatile samples, there is a dimple on the cup exterior floor for venting and a reservoir for overflow.
  • The Sample Cell is designed to produce a flat, tight and wrinkle-free membrane with any customary XRF membrane film product, ours or others.
  • Fully disposable. There is no need to disassemble them to recover reusable parts.
  • They are designed to work well with the aluminum jig tool furnished by Horiba for Horiba analyzers.

TECHREF® Sample Cells are 100% inspected.

TECHREF® Type H-2358 Sample Cells are made in the U.S.A.

Request Free Samples

Important Notes:

  • Handling of Sample Cells: Avoid touching the inside of the Sample Cell. Oil from fingerprints can affect the reading.

  • All XRF Sample Cells present the possibility of leakage, with potential damage to the analytical instrumentation. It is recommended that after the Sample Cell has been loaded with sample and assembled, check for any leaks. The use and application of this product is the sole responsibility of the user.

  • ®TECHREF Logo is Registered Trademark of TECHREF, INC.

SA05F06Y Rev. K